MSC-1 SPEED CONTROLLER (REPLACEMENT FOR ES02)

inkl. control circuit, CN1 connector, Operating Manual Controller Type Electronic Alarm Type Power Supply Input Voltage single-Phase 100/110/115 VAC±10% Single-Phase200/220/230 VAC±10% Power Supply Input Frequency 50/60 Hz Speed Setting Methods Set the speed in the following way. • Internal setting device • External Speed Potentiometer: Accessories (Sold separately)PAVR-20KZ (20 kΩ, 1/4 W) • External Voltage: 0–5 VDC & –10 VDC switching, 1 mA min. Function Speed Control, Instantaneous Stop, Bi-Direction, Speed Change, Acceleration/Deceleration (0.3-15 seconds: 1000 r/min At no load) Control Power Supply 24 VDC±10%, 100 mA min. Input Signal Photocoupler Input 4.7 kΩ FWD, REV, INT/EXT, ALARM-RESET Output Signal Open-Collector Output 30 VDC max. SPEED-OUT: 10 mA max., ALARM-OUT: 40 mA max. Protective Function When the following protective functions are activated, the motor will come to a coasting stop, and the alarm output will be turned OFF. The LED of the speed controller blinks the number of times in parentheses( ). • Motor Lock (2 Times): When the motor output shaft is restrained for 5 seconds min., or when the tachogenerator wire is disconnected or poorly connected. • Motor Overheat (9 Times): When the motor's built-in thermal protector operates (OPEN). When the motor wire is broken or poorly connected.