Voltage controllers
0,08-0,18 kW; 230 V +10-15%; 1,5A max. continuous current; 5 A max. start-up current
50/60 Hz; ambient temperature 0 to +45°C; Storage temperature -40 to +70°C
IP20; height 75 mm; depth 120 mm; Width 45 mm
Including installation and operating instructions
Electronic voltage control for electric motors for speed adjustment, or
Torque control on winding drives or also for electric heating systems after consultation
The voltage is over
- a setpoint potentiometer (2,5/10 kOhm)
- a voltage source 0...10 VDC
- one current input 0/4...20 mA
externally adjustable.
The limit values for minimum and maximum voltage can be set internally separately.
Suitable for 35mm DIN rail.
0,25-0,70 kW; 230 V +10-15%; 5 A max. continuous current; 15 A max. start-up current
50/60 Hz; ambient temperature 0 to +45°C; Storage temperature -40 bis +70°C;
IP20; height 75 mm; depth 120 mm; Width 45 mm
Including installation and operating instructions
Electronic voltage control for electric motors for speed adjustment
or torque control on winding drives or also for electric heating systems after consultation
The voltage is over
- a setpoint potentiometer 2,5 (10) kOhm
- a voltage source 0...10 VDC
- one current input 0...20 mA
externally adjustable.
The limit values for minimum and maximum voltage can be set internally separately.
Suitable for 35 mm DIN rail.
0,25-2,20 kW; 400 V +10-15%; 6 A max. continuous current; 30 A max. start-up current
50/60 Hz; ambient temperature 0 to +45°C; Storage temperature -40 to +70°C
minimum current 1,6 A (1,1 kW); IP20; HxBxT 75x85x120 mm three-phase controlled; 3-phase controlled
Electronic voltage control for capacitor motors for speed adjustment, or
Torque control on winding drives or also for electric heating systems after consultation
The voltage is over
- a setpoint potentiometer (2,5/10 kOhm)
- a voltage source 0...10 VDC
- one current input 0/4...20 mA
externally adjustable.
The limit values for minimum and maximum voltage can be set internally separately.
Suitable for 35mm DIN rail.
Three-phase voltage controller with electrically isolated control electronics
For adjusting torque and web tension on a three-phase winder; no minimum current required. Mains: 3 x 400 VAC ±10%, 50–60 Hz. Output: 3 x 0–400 VAC, three-phase phase-angle control; max. 3 x 0–5 A (motor). Setpoint: 0–10 VDC. IP20 with snap-on foot; dimensions W x H x D: 67 x 110 x 120 mm; one German documentation set. Motor reversal must be implemented externally with motor-side contactors. Additional setpoint input, controller inhibit, LEDs for mains on and start/stop. Optional at extra cost: Z4 tension controller for tension/compression/dancer control; B270 DC braking.