Power supplies / converters
- Entrance 85-264 Vac 50/60Hz (120-375 Vdc)
- Output voltage 24 Vdc ±2%
- Output power 480 W
- Rated output flow convection cooling 20 A
- incl. DC OK Relay Contact 30 V / 1 A
- Built-in reactive load constant circuit
- Full power for operation from -10°C to +50°C at 230VAC at 5000m altitude
- Built-in relay contact DC OK*
- SEMI F47 compliant
- Conformal coating of the printed circuit boards as protection against common dust and chemical pollutants
- Efficiency at 100% Load 85% type. @ 115 Vac, 88% type. @ 230 Vac
- Full power from -20°C to +50°C operation at 230Vac @ 5,000 meters
- Dimensions (H x W x D): 123.6 x 85.5 x 128.5 mm
- Parallel operation possible for performance enhancement
- Output voltage setting range 22-28 VDC
- Entrance AWG 16-12
- Output AWG 16-14 (2 wire pieces), AWG 12
- Support rail standard TS35 DIN rail according to EN 60715
- Noise (1 meter from the power supply) Sound pressure level (SPL) < 25 dBA
- Operation -20 °C to +70 °C / Storage -40°C to +85°C
- Protection: 28,4 V overvoltage – 35,2 V, SELV output, latch mode, overload / overcurrent 109–130 % of rated load current, continuous current, overtemperature latch mode, short-circuit hiccup mode, non-self-holding (auto-recovery if the fault is corrected)
- MTBF Telcordia SR-332 > 700.000 hours I/P: 100 VAC, O/P: 100 % load, Ta: 25 °C
- Expected life of cap 10 years (115 VAC & 230 VAC, 50 % load at 40 °C)
*The relay contact is normally "EIN" (closed) when the output is on (Vout) is greater than 90 % of its nominal value.
Inverters can supply standard household appliances with electricity.
For this purpose, batteries which are dimensioned with 12 V, 24 V or 48 V DC are used.
The inverters are short-circuit-proof and protected against overheating (whether caused by overload or by ambient temperature).
High switched-on power. This is required for switching on loads such as voltage converters for LED lamps, halogen lamps or power tools. ECO mode: In ECO mode, the inverter switches to standby as soon as the load drops below a preset value (minimum load: 15W). In standby mode, the inverter then switches on for a short period of time (regulateable standard setting: every 2,5 seconds. If the load exceeds a preset threshold value, the inverter remains switched on. Remote-controlled on/off control: A remote-controlled on/off switch can be connected to a two-pole plug or between the positive pole of the battery and the left contact of the two-pole plug.
Fully configurable:
threshold values for triggering and resetting alarms in the case of low battery charge.
• Threshold values for switching off and restarting at low battery voltage values.
• Dynamic shutdown: Load-dependent cut-off threshold
• Output voltage 210 -245V
• Frequency 50 Hz or 60 Hz
• Threshold for ECO mode on/off and ECO mode sensor
Monitoring:
• Input and output voltage, % load and alarms
battery terminal screw terminals; Contrast Performance at 25°C: 375 VA; peak power 700 W; output AC voltage / frequency (regulable) 230 VAC or 120VAC +/-3% 50 Hz or 60 Hz +/-0,1%; input voltage range 9,2 -17 / 18,4 -34,0 / 36,8 -62,0 V; Detection battery charged (regulateable) 14,0 / 28,0 / 56,0V; Max. efficiency 90 / 90 / 91%; Zero load power 6 / 6,5 / 9W; Default zero load power in ECO mode (default re-test interval): 2,5 s, adjustable) 1 / 1,5 / 3,0W; Stop settings for ECO mode and start performance controllable; operating temperature range -40 to +65°C (fan ventilation) (reduction of the power 1,25% per °C above 25°C); humidity (non-condensing) max 95%; Material & Color Steel Case and Plastic Cover (BLUE RAL 5012); Maximum cross section of the cable 10 mm2 / AWG8; Standard AC outputs 230V Schuko (CEE 7/4), IEC-320 (plug supplied)
protection class IP 21; Dimensions (HxBxT, 86 x 165 x 260 mm)
Optional accessories:
VE.Direct Bluetooth Smart Dongle
- Battery alarm
BMV battery monitor
VictronConnect
With VictronConnect, you can request live status information and configure any Victron product that either has a built-in Bluetooth feature or is connected to a VE.Direct Bluetooth Smart Dongle.
Android
https://play.google.com/store/apps/details?id=com.victronenergy.victronconnect
Windows
http://updates.victronenergy.com/feeds/VictronConnect/windows/w7/VictronConnectInstaller.exe
Apple
https://itunes.apple.com/us/app/victron-connect/id943840744?mt=8
Mac
https://itunes.apple.com/us/app/victronconnect/id1084677271?ls=1&mt=12