Watertight small helical geared motors
- Geared motors that conform to IEC Standard IP67, O-ring employed at motor/gear case junction
- Suitable for use in locations where the equipment is splashed or needs to be washed with water periodically
- Output powers of 25 W, 40 W, 60 W and 90 W are available
- Special anti-corrosive coating
- Stainless steel shaft with oil-shield protection
- Recognized by UL/CSA Standards and conforms to CE Marking (Low Voltage Directive).
These motors are also certified under the China Compulsory Certification System (CCC System)
- Output power: 25 W
- Motor Frame size: 83 mm
- RoHS compliant
- incl. a codenser with protective cap for AC motors
Includes fixing screws, washers and nuts of corrosion-resistant steel
The engine speed is calculated by synchronous engine speed (50 Hz): 1500 min-1, 60 Hz: 1800 min-1) is divided by the transmission reduction.
Depending on the load, the actual speed 2-20 % is lower than the value listed here.
Precautions in wiring
The terminals of the motor cable are not watertight. Make sure that no water gets to the clamps. Otherwise, the water can
pass into the motor via the feed wire or the cotton yarn, which can lead to damage to the motor.
- Motor Frame size: 90 mm
- RoHS compliant
- incl. a codenser with protective cap for AC motors
Includes fixing screws, washers and nuts of corrosion-resistant steel
The engine speed is calculated by synchronous engine speed (50 Hz): 1500 min-1, 60 Hz: 1800 min-1) is divided by the transmission reduction.
Depending on the load, the actual speed 2-20 % is lower than the value listed here.
Fixing screws, including washers and nuts of corrosion-resistant steel are included.
Precautions in wiring
The terminals of the motor cable are not watertight. Make sure that no water gets to the clamps. Otherwise, the water can
pass into the motor via the feed wire or the cotton yarn, which can lead to damage to the motor.
- Motor Frame size: 90 mm
- RoHS compliant
- incl. a codenser with protective cap for AC motors
Includes fixing screws, washers and nuts of corrosion-resistant steel
The engine speed is calculated by synchronous engine speed (50 Hz): 1500 min-1, 60 Hz: 1800 min-1) is divided by the transmission reduction.
Depending on the load, the actual speed 2-20 % is lower than the value listed here.
Fixing screws, including washers and nuts of corrosion-resistant steel are included.
Precautions in wiring
The terminals of the motor cable are not watertight. Make sure that no water gets to the clamps. Otherwise, the water can
pass into the motor via the feed wire or the cotton yarn, which can lead to damage to the motor.
- Motor Frame size: 104 mm
- RoHS compliant
- incl. a codenser with protective cap for AC motors
Includes fixing screws, washers and nuts of corrosion-resistant steel
The engine speed is calculated by synchronous engine speed (50 Hz): 1500 min-1, 60 Hz: 1800 min-1) is divided by the transmission reduction.
Depending on the load, the actual speed 2-20 % is lower than the value listed here.
Fixing screws, including washers and nuts of corrosion-resistant steel are included.
Precautions in wiring
The terminals of the motor cable are not watertight. Make sure that no water gets to the clamps. Otherwise, the water can
pass into the motor via the feed wire or the cotton yarn, which can lead to damage to the motor.