Size: 100 Prepared borehole possible: From Ø42 mm to Ø110 mm Design: Two-part, torsionally elastic, breakdown-proof shaft coupling Rated torque TKN: 2.900 Nm Maximum torque TKmax: 5.800 Nm Alternating torque TKW: 1.160 Nm Maximum speed at v = 35 m/s: 2.950 min⁻¹ Total length LAR: 206 mm Hub length l1: 100 mm Maximum axial offset ΔKa: ± 3,0 mm Maximum radial offset ΔKr: 0,50 mm Max. angular offset ΔKw: 3,9° Hole: H7 Groove: DIN 6885 Sheet 1 / JS9 Mounting: Threaded pin on keyway
Installation instructionsWhen assembled, the coupling halves must be extended to such an extent that the coupling and shaft are flush. The alignment must be carried out in such a way that the radial and angular offset is as small as possible. The service life of the coupling and bearings is increased by accurate alignment. Suitable measures must be taken to ensure that the alignment state cannot change in all operating states. Inevitable shaft displacements should not exceed the values set out in the table. Angular and radial offset can occur at the same time. The sum of the offsets shall not exceed the above table values.
Please see our privacy notice
