Battery motor controller A2-100 FOUR-QUADRANT BUILT-IN UNIT WITH ANALOGUE ENERGY REGENERATION

Motor In/Imax 5s: 050 A / 100 A Input voltage: 12 to 48 VDC Auxiliary voltage connection required: 24VDC ±20% max. 0,5A, waviness <20% Ausgangsspannung max. : 0,95 x Eingangsspannung degree of protection : IP53 Feuchtebeanspruchung : Klasse F nach DIN 40040 keine Betauung; Betriebsbereich : 0…45°C (60°C); Temperaturüberwachung 80°C Regelbereich : 1:1000; Regelgenauigkeit ±0,5% o. Istwertfehler Querschnitt Anschluß : Batterie min. 35 mm² bei 2 m (>5m additional capacitors required; Motor min 25 mm2; Safety 200 A Dimensions HxBxT: 120x137x70 mm The cooling plate can dissipate only a small power loss (about 50W). Further power loss must be dissipated through the mounting surface or an additional cooler (steel sheet is a poor heat conductor). - When energy is returned, ensure that the intermediate circuit overvoltage is limited to 20% and the power connection is not disconnected (throughput current = appliance peak current); Safeguarding with reverse current protective diode D1 - Setting the target value Speed and current limitation ±10V via optional 5 kOhm potentiometer or by reference value current 0...±20 mA - reversal of the direction of rotation with bipolar setpoint value or sep. Predetermination of the direction of rotation - speed control and/or current control (torque control) - combined speed current control (specify when ordering) - Static and dynamic current limit (temperature control) - Measurement outputs for current and speed - Brake logic, main protector logic, release logic with quick stop Power electronics with IGBT power semiconductors, generously dimensioned (Attention:) no reverse polarity protection possible, output stage can be destroyed DC tachogenerator connectable at maximum speed min 5 VDC, max 25 VDC Use series resistor at higher voltages incl. German installation and operating instructions When ordering, specify the exact battery and motor voltage!